Advertisement · Billboard Skin · 1920×350, 1920×150 on scroll · Hidden until filled

Don’t Let a Wet Fall Follow Soybeans Into Storage

After a wet fall increased risk of mold, sprouting and purple seed stain in parts of the Midwest, careful drying, cooling and aeration will be critical to maintaining soybean quality in storage. 

“A lot of the initial quality concerns were the moldy soybeans, the ones that truly did get wet and molded within the pod,” said Matthew Vandehaar, Pioneer Field Agronomist. “We certainly had some smaller levels of sprouting that occurred on some of the upper pods, along with some purple seed stain. In general, it was the mold that concerned us most for storage.” 

Consider running harvested soybeans through pre-storage screeners and cleaning operations. Cleaners remove split beans and eliminate pockets of moisture and foreign material that may protect molds and fungus. 

If a grower saw sprouted seeds, mold or deep purple discoloration, the soybeans should be quickly dried to 13% moisture to mitigate continued fungal metabolic activity. Soybeans with these issues should be prioritized to be delivered to the elevator. If planning for long-term storage, the beans may be carefully dried to 11% to 12% moisture, although lower moisture levels can increase the risk of splitting. Growers should also account for moisture loss each time soybeans are moved.

After drying, cool grain bins to 35 to 40 degrees Fahrenheit as soon as outdoor temperatures cool. Stored soybeans should be kept within approximately 10 to 15 degrees Fahrenheit of the outside air and roughly the same temperature throughout the bin to help keep the grain mass uniform and minimize moisture migration. 

As the outside air cools, air near the bin walls falls to the bottom, pushing warmer, moister air up through the center of the grain, causing pockets of condensation. Aeration can prevent these wet pockets, which equalizes temperature within stored grain and moves it closer to the outside air temperature.  

Because outside air can either dry or rewet stored soybeans, growers should check temperature and relative humidity before running fans. An equilibrium moisture content table or calculator can help determine whether conditions are suitable for aeration.  

After the target winter storage temperature is reached, the soybeans should be inspected every two weeks for moisture accumulation or crust development. The fans can be turned on for 15 to 30 seconds to check for a musty or rotting smell that can signal deteriorating grain condition.  When the fans are not in use, make sure to cover the intake to avoid frost forming on the roof and melting into the seed. After snow and wind events, check to make sure snow has not sifted into the bin.  

Temperature and CO2 monitors can provide additional insights into the condition of stored soybeans. If the grower needs to enter the bin, always follow proper grain-bin safety procedures during inspections. Shut down and lock out electrical power, fans and unloading equipment before entering the bin, and never enter without someone else nearby in case help is needed. When working around moldy grain, wear appropriate respiratory protection. 

For extended periods of storage, grain should be warmed in increments of 5 degrees or less in the spring to maintain quality. During the late spring and summer months, grain temperature should be about 45 degrees Fahrenheit. This can be done by operating the fan on cool, dry nights. 

Written by